Zanussi ZWG
E10
|
Washing machine has not filled with water in allocated time – not filling with water
The level sensor has not detected a change in water level three minutes after fill valve energised.
· Check water supply is on
· Check inlet valve is not block
· Check inlet hose is not kinked
· Check drain hose installation is high enough etc.
· Check water valve
· Check wiring
|
E11
|
Washing macine has detected an overfill of water – over filling with water
· Check drain pump for blockage or obstruction
· Check drain hose for blockage or obstruction
· Check drain pump
· Check fill valve is not jammed open or leaking
· Check electronic control module
|
E12
|
Overflow – overfilling with water
Water level has exceeded the overfill level on the pressure switch or sensor
· Check water valve
· Check level switch or sensor
· Check electronic controller
|
E20
|
Washing machine drain pump not detected – not draining or emptying
· Check wiring to drain pump
· Check drain pump for continuity
|
E21
|
Water not drained from washing machine in allotted time – not draining or emptying
The level sensor has not detected that the washing machine has been drained inside three minutes
· Check the washing machine filter for any blockage or obstructions
· Check the drain pump for any blockage or obstruction
· Check the outlet drain hose for any blockage or obstruction
· Check wiring to water pump
· Check water pump for failure
· Check level switch
· Check electronic controller
|
E30
|
Washing machine door not detected as being locked by controller – machine will not start
The electronic controller has failed to detect that the door has been properly locked
· Check the door is closed
· Check the door latch
· Check the door lock
· Check the door lock wiring
· Check the electronic controller
|
E31
|
Error detected with washing machine pressure sensor – machine will not start
· Check wiring to level sensor
· Check level sensor
|
E33
|
Error detected with washing machine pressure sensor – washing machine will not start
· Check wiring to level sensor
· Check level sensor
|
E34
|
Temperature sensor error – washing machine will not heat water
· Check wiring to temperature sensor
· Check temperature sensor
|
E60
|
Washing machine motor does not work – no drum action or rotation or not spinning
· Check motor wiring
· Check motor
· Check electronic controller
|
E61
|
No tacho signal from motor detected by controller – no motor action, drum not turning or not spinning
· Check wiring to motor
· Check wiring to electronic controller
· Check electronic controller
|
E62
|
Motor signal is abnormal
· Check motor wiring
· Check electronic control wiring
· Replace controller
|