Error codes – Πλυντήρια πιάτων Whirlpool VBL


Whirlpool VBL

F0
10 Flashes
Only use in test program, indicates sensor failure
This fault code should never be visible.
F1
1 Flash
NTC or thermistor open circuit
Usually it is exactly what it says and the NTC has failed.
F2
2 Flashes
Water leak detected
This will be a float switch in the base normally that has been activated due to a leak of some sort.
F3
3 Flashes
Heating system defective
Nine out of ten times this will be a faulty heater.
F4
4 Flashes
Failure to drain out
Drain pump blocked or faulty is usually the cause of this fault code being displayed.
F6
6 Flashes
No incoming water
Check the water is on and the supply is okay and then the water valve.
F7
7 Flashes
Flow meter failure
This is the small flow meter fitted to the fill matrix of the dishwasher.
F8
8 Flashes
Water level fault
F9
9 Flashes
Continuous water inlet

 

Author: tapavakos

Ψυκτικός

Leave a Reply