Error codes – Πλυντήρια ρούχων AEG Lavamat 8*** Series

AEG Lavamat 8*** Series 
C0
Pressure switch fault
·         Imbalance between both washing machine Pressure Switches
·         Water heater or wiring fault
C1
No water intake
·         Water valve at fault
·         Low water pressure
C2
Drain pump blockage
·         Drain pump open circuit
·         Water drainage blocked
C3
Safety flood device or switch operated
·         Drain pump fault
·         Electronic module fault
C4
Wash pump faulty
·         Water drain pump faulty
C5
Overheat sensor on main motor activated
·         Main drive motor faulty
C6
Pressure switch fault
·         Water level switch or sensor faulty
C7
Heater or heater relay fault
·         Check heater for continuity
·         Check module
C8
NTC temperature sensor fault detected
·         Check NTC for short or open circuit
·         Check wiring
·         Check module
C9
Motor tacho fault
·         Check main drive motor
·         Check tacho magnet
·         Check tacho coil
·         Check module
CA
MOS-FET transistor for motor triac on main board defective
·         Replace main module
CB
Overfill or level fault
·         Check level switch or sensor
·         Check water inlet valve
CC
PTC for MOS-FET transistor fault
·         Main motor fault, replace motor
CD
Door interlock fault
·         Check wiring
·         Check washing machine door lock
·         Check door latch etc.
CF
Checksum EEPROM failure
·         Configuration error on module, replace electronic control module

Author: tapavakos

Ψυκτικός

Leave a Reply